Block current

[nitrx]

Hi how do I disable UV in the block current conditions I've no solar nor uv sensor.
Thanks in advance (url http://apeldoornmeteo.nl )
Ron

[Johnny]

Hi Ron, if you don't have a solar sensor, go to the Administration section of your site, click on Main Setup and scroll about a quarter of the way down the page until you see Solar Sensor and change the setting to 'No'

John

[Jachym]

The reason you are seeing this is because whichever means of update you are using, is actually sending UV data (as 0, but it should not send anything, otherwise the template thinks you have this sensor).

Here is raw data sent to the API:

http://apeldoornmeteo.nl/meteotemplateLive.txt

You can see UV there

[nitrx]

Hi Ron, if you don't have a solar sensor, go to the Administration section of your site, click on Main Setup and scroll about a quarter of the way down the page until you see Solar Sensor and change the setting to 'No'

John

Thanks for thinking with me, it was alreay set to 'no' , I saved again but still uv shows up
Ron

[nitrx]

The reason you are seeing this is because whichever means of update you are using, is actually sending UV data (as 0, but it should not send anything, otherwise the template thinks you have this sensor).

Here is raw data sent to the API:

http://apeldoornmeteo.nl/meteotemplateLive.txt

You can see UV there

Aha I now the problem I've a WH3080 so uvi data is sent, unfortunally the sensor is broken so no data comes in
well have to live with it , thanks anyway.